Specifications - Sanyo DWM-3000 Instruction Manual

Dvd & hi-fi vcr home theater
Table of Contents

Advertisement

Amplifier Section
Inputs:
VIDEO (AUDIO) IN: 500 mV/50 kΩ
Outputs:
SUBWOOFER PRE OUT: 2 V/1 kΩ
COMPONENT VIDEO OUT:
Y: 1.0 Vp-p (75 Ω)
PB: 0.7 Vp-p (75 Ω)
PR: 0.7 Vp-p (75 Ω)
MONITOR OUT S-VIDEO:
Y: 1.0 Vp-p (75 Ω)
C: 0.286 Vp-p (75 Ω)
MONITOR OUT VIDEO: 1.0 Vp-p (75 Ω)
VCR Specifications
Head system:
Four head helical scan azimuth system
Timer:
12-hour display type with AM, PM
Tape speed SP:
33.35 mm/sec, LP: 16.67 mm/sec, EP: 11.12 mm/sec
Tape width:
12.7 mm
Maximum recording time:
SP: 2 HOURS (T-120), EP: 6 HOURS (T-120)/8 HOURS (T-160)
Rewind time:
About 3 minutes (T-120)
Antenna:
75 ohms (VHF/UHF)
VHF output signal:
Channel 3 or 4 (Switchable)
Channel coverage VHF:
2-13, UHF: 14 – 69, CATV: 1 – 125 (4A, A–W, W+1 – W+84, A-5 – A-
1)
Frequency range:
20 Hz to 20 kHz
Signal-to-noise ratio:
More than 43dB
Dynamic range:
More than 83 dB
Channel separation:
More than 55 dB
DVD Video Player Section
Type:
DVD Video player
Signal format:
NTSC color
Laser:
Semiconductor laser, wavelength 650 nm/790 nm
Signal to noise ratio:
More than 105 dB
Wow and flutter:
Below measurable level
Tuner Section
(FM)
Frequency range:
87.9 MHz – 107.9 MHz (200 kHz steps)
Usable sensitivity:
20.2 dBf (mono)
(AM)
Frequency range:
520 kHz – 1,710 kHz (10 kHz steps)
Usable sensitivity:
500 µV/m (AM loop antenna)
IMPORTANT INFORMATION
Because its products are subject to continuous improvement, SANYO reserves the right to modify product designs and specifications
without notice and without incurring any obligation.

SPECIFICATIONS

General
Power requirements:
AC 120V, 60 Hz
Power consumption:
110 Watts
Dimensions (W x H x D):
Approx. 17.1" x 3" x 14.8" (435 x 75 x 375 mm)
Weight:
Approx. 14.1 lbs (6.4 kg)
Active Subwoofer (ASX-3000)
Subwoofer
Continuous minimum sine wave RMS power output
into 6 ohms at 70 Hz with no more than 10 % total harmonic
distortion ............................................................................... 75 Watts
Satellite Speakers (Front Left & Right, Center, Surround Left &
Right)
Continuous minimum sine wave RMS power output per channel
into 8 ohms at 1 kHz with no more than 10 % total harmonic
distortion (with the other amplifiers off) ............................. 25 Watts
AUDIO INPUT (6-CHANNEL):
DIN 9-pin
SPEAKERS (Output):
FRONT (L/R): 8 Ω
CENTER: 8 Ω
SURROUND (L/R): 8 Ω
Power requirements:
AC 120V, 60Hz
Power consumption:
150 Watts
Unit used:
6.5" (16 cm) diameter, Cone type
Dimensions (W x H x D):
Approx. 9.1" x 15.4" x 13.8" (230 x 390 x 350 mm)
Weight:
Approx. 22.1 lbs (10 kg)
Satelite Speaker
Front left, Front right, Center, Surround left, and Surround right
speakers (STM-8501S, magnetic shield)
Unit used:
3.1" (8 cm) diameter, Cone type, Full range
Maximum music power handling capacity:
60 Watts
Nominal impedance:
8 Ω
Dimensions (W x H x D):
Approx. 5.9" x 4.3" x 4.5" (150 x 110 x 115 mm)
Weight:
Approx. 1.6 lbs (0.73 kg)/speaker
-E62-
950 mV/47 kΩ (Subwoofer)
2300 mV/1.5 kΩ (Satellite)

Advertisement

Table of Contents
loading

Table of Contents