Lexus IS300H 2017 Manual page 149

Switching the door unlock function (vehicles with entry function)
■
It is possible to set which doors the entry function unlocks using the wireless remote con-
trol.
Turn the power switch off.
1
Cancel the intrusion sensor and tilt sensor of the alarm system to prevent unintended
2
triggering of the alarm while changing the settings. (if equipped) (P. 95)
When the indicator light on the key surface is not on, press and hold
3
for approximately 5 seconds while pressing and holding
The setting changes each time an operation is performed, as shown below. (When
changing the setting continuously, release the buttons, wait for at least 5 seconds, and
repeat step .)
3
Multi-information
display
(Left-hand drive
vehicles)
(Right-hand drive
vehicles)
For vehicles with an alarm: To prevent unintended triggering of the alarm, unlock the
doors using the wireless remote control and open and close a door once after the set-
tings have been changed. (If a door is not opened within 30 seconds after
pressed, the doors will be locked again and the alarm will automatically be set.)
In a case that the alarm is triggered, immediately stop the alarm. (P. 93)
3-2. Opening, closing and locking the doors and trunk
Unlocking function
Holding the driver's door handle
unlocks only the driver's door.
Holding the front passenger's
door handle unlocks all the
doors.
Holding either front door handle
unlocks all the doors.
,
.
Beep
Exterior: Beeps 3 times
Interior: Pings once
Exterior: Beeps twice
Interior: Pings once
149
or
3
is