Table of Contents
Advertisement
Features
&
Controls
The high beam headlights will come on
at reduced brightness in daylight when:
The ignition is on
The headlight switch is off, and
The parking brake is released.
When you turn on your headlights, the
DRL will switch off and the exterior
lights will come on. When you turn off
the headlights, the exterior lights will go
out and the high beams will change to
the reduced brightness of DRL again.
The DRL indicator light on the
instrument panel will go on whenever
the DRL are on. This light means that
only the DRL are on. When you turn on
your exterior lights, this light will go
out. Of course, you may still turn on the
headlights any time you need to.
To idle your vehicle with the DRL off,
set the parking brake. The DRL will
stay off until you release the parking
brake.
J
Headlight High-Low Beam
Changer
To change the headlights from low
beam to high or high to low, pull the
turn signal lever all the way toward you.
Then release it. When the high beams
are on, a blue light on the instrument
panel also will be on.
Flash-to-Pass
(EXCEPT CANADA)
Flash-to-Pass lets you use your high
beam headlights to signal a driver in
front of you that you want to pass.
To use it, pull the turn signal lever
toward you, then release.
If Your Headlights
Are Off
Your high beam headlights will turn on.
They'll stay on as long as you hold the
lever there. Release the lever to turn
them off.
If
Your Headlights Are On:
Flash-to-Pass does not operate when
your headlights are on. Use the lever to
change between high and low beams.
Advertisement
Table of Contents
