Kaya Instruments JetCam User Manual page 54

4. Make sure that everything is in check and that
there are no visible gaps, especially on the contact
surface between the mount and the front panel:
the mount should sit flush against the panel with no
gaps.
5. Cover the mount with the mount cover
immediately after
everything is in order. This is critical in order to
protect the sensor from dust and dirt.
www.kayainstruments.com
finishing and verifying
2 0 H a M e s i l a S t . , N e s h e r 3 6 8 8 5 2 0 , I s r a e l
P O B 2 5 0 0 4 , H a i f a 3 1 2 5 0 0 1 , I s r a e l
T e l : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 0 0 F a x : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 1 1
Figure 49 – The assembled mount
Figure 50 – Covered lens mount
Page no. 51 | Appendix