Mechanical Properties; Link Status Leds - Kaya Instruments JetCam User Manual

5 Mechanical Properties

This section provides information on JetCam camera unit hardware. It covers architecture, interfaces and pin
assignments for various connectors.
Power Connector
System status LED
Serial Connector

5.1 Link Status LEDs

The QSFP+/SFP+ bi-color LEDs are located below the QSFP+/SFP+ connectors. Color-coded indication along with
exact timing for each indicator are described in the following tables:
LED state
Off
Solid orange
Solid red
Fast flash alternate green / orange
Solid green
Fast flash green
Slow pulse orange
Indication
Fast flash
Slow flash
Slow pulse
www.kayainstruments.com
NC GND
12V
Link Status LEDs
Figure 1 – JetCam camera interfaces
Indication
Camera is not powered
Camera is booting
Camera is powered but no active connection
Fast flash alternate green / orange - Connection detection in progress
Camera is connected, no data being transferred
Camera is connected, data is being transferred
Camera is connected. Waiting for trigger event
Table 2 – Link connector indicating lamp states
Timing
12.5Hz (20ms on, 60ms off)
0.5Hz (1s on, 1s off)
1Hz (200ms on, 800ms off)
Table 3 – Connector indicating lamp timings
2 0 H a M e s i l a S t . , N e s h e r 3 6 8 8 5 2 0 , I s r a e l
P O B 2 5 0 0 4 , H a i f a 3 1 2 5 0 0 1 , I s r a e l
T e l : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 0 0 F a x : ( + 9 7 2 ) - 7 2 - 2 7 2 3 5 1 1
QSFP Connector
GPIO Connector
SDI Connector
Page no. 7 | Mechanical Properties