Table of Contents
Advertisement
158
6-1. Rear view monitor system
■
When the ground behind the
vehicle slopes down sharply
The distance guide lines will appear
to be farther from the vehicle than
the actual distance. Because of
this, objects will appear to be closer
than they actually are. In the same
way, there will be a margin of error
between the guide lines and the
actual distance/course on the road.
■
When any part of the vehicle
sags
When any part of the vehicle sags
due to the number of passengers or
the distribution of the load, there is
a margin of error between the fixed
guide lines on the screen and the
actual distance/course on the road.
YARIS_NAVIGATION AND MULTIMEDIA SYSTEM OWNER'S MANUAL_Europe_MK0019_en
A
A margin of error
When approaching three-
dimensional objects
The distance guide lines are dis-
played according to flat surfaced
objects (such as the road). It is not
possible to determine the position
of three-dimensional objects (such
as vehicles) using the vehicle width
guide lines and distance guide
lines. When approaching a three-
dimensional object that extends
outward (such as the flatbed of a
truck), be careful of the following.
■
Vehicle width guide lines
Visually check the surroundings
and the area behind the vehicle. In
the case shown below, the truck
appears to be outside of the vehicle
width guide lines and the vehicle
does not look as if it hits the truck.
However, the rear body of the truck
may actually cross over the vehicle
width guide lines. In reality if you
back up as guided by the vehicle
width guide lines, the vehicle may
hit the truck.
Advertisement
Table of Contents
