DEAR CUSTOMER! Some provisions in this user manual are unified for refrigerating products of different types (for a refrigerator, refrigerator-freezer or freezer). CAREFULLY READ THE INSTRUCTION MANUAL. The Manufacturer shall not be held liable for damage arising from the failure to observe the instructions contained in this manual.
Page 3
Avoid sparks-do not turn on any electrical appliances or lighting fixtures. • Immediately ventilate the room: air the room in which the appliance is placed for a • few minutes (the size of the room for a product containing isobuthane / R600a must be at least 4 m ) to avoid damage to the cooling system.
Page 4
Do not use adapters, multiple sockets and two-wire extension leads. If it is – necessary to use the extension lead, it must be equipped with a protection ring and a single socket and must have a VDE/GS safety certificate. If an extension lead is used (with a protection ring and safety certificate), its socket must be located at a safe distance, away from the sinks, and must not be in a place where it could be flooded by water or waste water.
The appliance should be transported in the vertical position; do not tilt any more than 30°. The manufacturer will not be responsible for any damage of the appliance that results from non-compliance with the instructions for transportation. The manufacturer guarantees reliable operation of the refrigerator when the relative air humidity not greater than 70 per cent and the ambient temperature is: +16 TO +32 DEGREES CELSIUS (Climate class N);...
of the appliance rises, by turning them counter clockwise – it comes down. If the appliance is tilted slightly backward – the doors will close by themselves. If the appliance is placed in a corner, a gap must be left between the appliance body •...
Page 7
DESCRIPTION OF THE APPLIANCE, BASIC PARTS (Fig. 1) 1 Control panel Condenser 2 Fast-freeze section Compressor 3 Frozen products section(s) 4 Shelf for bottles NOTE. The technical data of the appliance can be found on the rating label attached to the inside wall of the appliance.
Page 8
ELECTRONIC CONTROL PANEL DESCRIPTION, TEMPERATURE REGULATION When connecting the device to the mains for the first time, the blue temperature indicating segment lights up at -20 (factory temperature setting -20 °C, but you can select the preferred temperature according to your needs). 1 - Temperature adjustment button.
Page 9
STORAGE AND FREEZING OF FOODSTUFFS To avoid food contamination, follow the instructions below: Prolonged opening of the door can significantly increase the temperature in the • compartments of the appliance: only open the door for the time required to place / remove food.
DEFROSTING, CLEANING AND CARE FREEZER COMPARTMENT gets defrosted automatically: it operates a frost-free cooling system (No Frost). However, according to how often the freezer door were opened and closed, and to - how warm products were placed into the appliance, the frost can accumulate on walls of freezer inner liner and drawers.
Page 11
3. Unscrew the shaft 2 from the lower bracket 7. Screw it together with all the washers into the bracket 7 on the other (opposite) side, symmetrically to the former position (see figure). Slide the door onto the 7 axles of the bracket. 4.
Page 12
OPERATION PROBLEMS AND THEIR SOLUTIONS The appliance is plugged in to the mains but it does not work. Check that your • house electricity supply installations are in order. Check that the plug is correctly inserted into the electricity supply socket. Temperature segment in centre of button is red.
ENVIRONMENTAL PROTECTION INFORMATION Important Note: This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
Need help?
Do you have a question about the F 27FG and is the answer not in the manual?
Questions and answers