SAFETY INSTRUCTIONS Carefully read the Instruction manual! If instructions are not followed, there is a risk of injury, damage of the appliance and loss of the right to free warranty service. We recommend to keep the Instruction manual the whole time you have the appliance.
Page 3
IF THE APPLIANCE IS PRODUCED WITH THE SPECIAL SUPPLY CORD IT CAN BE EXCHANGED ONLY BY THE SAME SPECIAL SUPPLY CORD PROVIDED BY THE MANUFACTURER. TO AVOID HAZARDS, DAMAGED POWER SUPPLY CORDS SHOULD BE REPLACED ONLY BY THE MANUFACTURER, A MAINTENANCE TECHNICIAN, OR A PERSON WITH AN EQUIVALENT QUALIFICATION.
Inside temperature class – S (from –2 °C to +14 °C) Product data sheet Data according to requirements of standard EN ISO 23953-2:2005 Model CD40DM Total gross volume, L Net volume, L Dimensions (H x W x D), cm 202,5 x 60 x 61 Shelf area, dm Average air temperature inside the refrigerator, °C...
Page 5
DESCRIPTION OF THE APPLIANCE, BASIC PARTS Advertising panel Thermostat dial Shelves Interior lighting on/off button Condenser Advertising panel light on/of button Thaw water drip tray LED lighting (ceiling) Compressor 1 - THERMOSTAT DIAL. The temperature is indicated on the thermostat dial. Turning the thermostat dial clockwise reduces the temperature in the chamber.
PREPARING THE APPLIANCE FOR OPERATION It is recommended to prepare the appliance for operation with a helper. Remove package. Lift the appliance away from foamed polystyrene base. • If your appliance is fit with screwed handles. Do not rise or push it taking by handles. •...
TEMPERATURE REGULATION The temperature in the appliance is controlled using the thermostat dial 2 (see fig. 1) by turning it to one side or the other. Turning the thermostat dial clockwise reduces the temperature in the chamber. The temperature is indicated on the thermostat dial. The temperature is regulated on the scale of five digits.
Page 8
ATTENTION! Outer of the doors – glass – clean with agents intended for glass • cleaning. IF THE APPLIANCE IS TO BE LEFT SWITCHED OFF FOR AN EXTENDED PERIOD, • LEAVE ITS DOORS OPEN. Remarks on the appliance operating noise. As the appliance operates and goes through the freezing cycle, various noises will be emitted.
Page 9
CHANGING THE OPENING DIRECTION OF THE DOORS It is recommended that changing the opening direction of the doors should be done with a helper. When changing the opening direction of the doors YOU CAN NOT lay the refrigerator horizontally! Do the actions below in the order they are listed: Turn off the appliance and pull the plug out of the electricity supply socket.
7. Remove the mounting screws (2) from the door, separate the handle (3) and attach it by screwing the screws into the holes on same side (handles are reinstalled in the case of doors with an aluminum frame). 8. Using the supplied washers and gaskets, attach the lower bracket (10) on the opposite side of the cooler, but first attach the bracket axle to the door.
Need help?
Do you have a question about the CD40DM and is the answer not in the manual?
Questions and answers