Mic Base Unit Replacement (Camera Recorder Only); Reel Drive Motor Unit Replacement (Except Camera Recorder); L-M Release Angle Unit Replacement (Except Camera Recorder) - Panasonic AJ-D440 Service Manual

1-26. MIC Base Unit Replacement
(Camera Recorder only)
(Removal)
1. Disconnect the connector P607 on the Servo
P.C.Board.
2. Unscrew the 2 screws (A) and remove the MIC
Base Unit as shown in Figure 1-26.
(Installation)
1. Install the new MIC Base Unit according to the
opposite procedures to removing.
2. Confirm that the M cassette touches to MIC Base
Unit properly.
Figure 1-26
1-27. Reel Drive Motor Unit
Replacement
(except Camera Recorder)
<CHART B>
Model Type
Connector (A)
P.C.Board (B)
(Removal)
1. Disconnect the connector (A) on the P.C.Board
(B).
2. Unscrew the 2 screws (A) and remove the Reel
Drive Sensor P.C.Board as shown in Figure 1-27.
3. Unscrew the 2 screws (B) and remove the Reel
Drive Motor Unit as shown in Figure 1-27.
(Installation)
1. Install the new Reel Drive Motor Unit follow the
removal step in reverse order.
TYPE A TYPE B
P16 P2016
MECH I/F SERVO
1-28. L-M Release Angle Unit
Replacement
(except Camera Recorder)
(Removal)
1. Unscrew the 2 screws (A) and remove the L-M
Release Angle Unit as shown in Figure 1-28.
(Installation)
1. Install the new L-M Release Angle Unit follow the
removal steps reverse order.
3-23
Figure 1-27
Figure 1-28