2.3.2 Mounting
Remember that this inverter is heavy! Please be careful when lifting out from the
package.
The inverter is suitable for mounting on concrete or other non-combustible surface only.
Step 1
Please use the mounting bracket as a template to drill 4 holes in the right positions
(10mm in diameter,and 80mm in depth).
Use expansion bolts in accessory box and fix the mounting bracket onto the wall tightly.
Note: Bearing capacity of the wall must be higher than 30kg.
228.5mm
228.5mm
07
400mm
Step 2
Carry the inverter by holding the heatsink on two sides and place the inverter on the
mounting bracket.
Wall Bracket
Expansion Pipe
117.5mm
104.5mm
Self-tapping Screws
Step 3
Ground cable shall be connected to ground plate on grid side.
Step 4
Inverter could be locked for anti-theft purposes if required.
The lock is not included in the package.
It can be purchased by user.
08