Safety Instructions; Symbols And Safety Labels; General Safety Information; Requirements For Users And Duties For Operators - Spectrum M2p.59 Series Hardware Manual

Symbols and Safety Labels

Safety Instructions

This chapter contains information about the following topics:

• General safety information

• Requirements for users and duties for operators

• Intended use
• Markings and Labelling
Symbols and Safety Labels

Table 1: Symbols and Safety Labels

Label Where
Cards
NETBOX chassis
Products
Products
NETBOX chassis
Manual
Manual
General safety information
Carefully read the documentation (Installation manual and hardware manual) that belongs to the product prior to the startup. Please observe
the product safety instructions and the following safety notices to avoid health issues or damage to the device.
The manufacturer does not assume any liability for damages resulting from improper handling, unintended use or non-observance of the safety
precautions.
Applicable regulations and laws governing the location and use of the product must be observed and all accident prevention and occupa-
tional safety regulations must be complied with.
Requirements for users and duties for operators
The product may be assembled, operated and maintained only if you have the necessary qualification and experience for this product. Im-
proper use or use by a user without sufficient qualification can lead to damages or injuries to one's health or damages to property. The as-
sembler of the system is responsible for the safety of any system incorporating the equipment.

General safety at work

The existing regulations for safety at work and accident prevention must be followed. All applicable regulations and statutes regarding op-
eration must be strictly followed when using this product.
8
Description
ESD symbol
Parts can be damaged by electrostatic discharge. Follow these precautions:
Avoid touching pins, leads, or circuitry.
Always be properly grounded when touching a static-sensitive component or assembly.
GND symbol
To enhance the immunity of the equipment against conducted and radiated RF disturbance, sensitive electrical circuits are connected to the
chassis.
Protective Conductor Class I
This movable devices of protection class I is equipped with a cable with additional protective conductor and a protective contact plug. The
device may only be connected to the protective conductor system of the fixed electrical installation, which is at ground potential.
Labelling for CE conformity
Spectrum confirms with the CE marking affixed to the product or its packaging that the product complies with the product-specific applicable
European directives. The CE declaration of conformity for the product is available upon request.
Labelling for WEEE
The WEEE symbol on the product or its packaging indicates that the product must not be disposed of with other waste. The user is obliged
to collect the old devices separately and to make them available to the WEEE take-back system for recycling.
Labelling for battery disposal
Batteries must not be disposed of with household waste. You are legally obliged to return old batteries so that proper disposal can be guar-
anteed. You can dispose of used batteries at a municipal collection point or in local stores
Important part of the manual with safety related content
Additional information inside the manual which helps to understand a topic in more detail
(c) Spectrum Instrumentation GmbH
Safety Instructions