Advertisement

Quick Links

®
pH 110 Meter
PRODUCT MANUAL
Item # 2120

Advertisement

Table of Contents
loading

Summary of Contents for Spectrum 2120

  • Page 1 ® pH 110 Meter PRODUCT MANUAL Item # 2120...
  • Page 2: Table Of Contents

    110 meter. Please read this manual thoroughly before using your instrument. For customer support, or to place an order, call Spectrum Technologies, Inc. (800)248-8873 or (815) 436-4440 between 7:30 am and 5:30 p.m. CST, FAX (815)436-4460, e-mail: specmeters.com.
  • Page 3: General Overview

    General Overview Thank you for purchasing the data logging pH 110 meter from Spectrum Technologies, Inc. This user’s guide deals with the features that are unique to the data logging pH 100 meter. Infor- mation on general meter operation is contained in the accompanying Instruction manual.
  • Page 4: Data Logger Operation

    Data Logger Operation The data logger has two modes of operation: Com- munication and Measurement. These modes are indicated by the green LED in the lower left corner of the meter. When this light is flashing, the meter is in Communication mode.
  • Page 5 Calibration The procedure for calibrating the meter is given in the accompanying meter instruction manual. Taking and Data Logging Measurements When the probe is inserted in soil or water, the me- ter’s LCD will immediately begin indicating the pH. When this value stabilizes, the meter locks on to that value and the LCD will display READY in the upper right corner.
  • Page 6: Identifying The Correct Com Port

    Identifying the Correct Com Port T h e c o m p u t e r Communications Port to which cable connected identified using paper clip. 1. Disconnect the serial cable from the meter. 2. To bring up the Port Selection screen, click on the Com Port Button, select the com port to be tested and click the Port Test button.
  • Page 7: Connecting To A Pc

    Connecting to a PC The pH 110 Meter software comes with a black PC interface cable. This cable connects to the USB port of your computer and to the meter’s computer port. The port is located at the base of the meter (marked RS-232).
  • Page 8: Logger Software

    Logger Software Meter Type The Field Scout software supports all of Spectrum Technologies’ portable data logging meters. Be sure to select the pH 100 Meter from the Select Meter Type screen Meter Settings Clicking on this button will bring up the Meter Set- tings screen.
  • Page 9 Download After clicking the Download button, a progress bar will confirm that data is being extracted from the log- ger. When completed, the Save Data As box will appear. From here you can give the data file a de- scriptive name and select a folder in which to save it. The folder selection field on the right allows you to browse to any folder in your system.
  • Page 10: Gps Connection

    GPS signal, check that it has the following set- tings: Data bits: 8 Stop bits: 1 Baud rate: 4800 bps Parity: None Timing: 1 second GGA data string SPAD pH110 Meter Meter Unit Spectrum GPS computer GPS/DGPS interface cable Cable...
  • Page 11 Initial GPS connect If the meter does NOT detect an incoming GPS signal, it will flash steadily for 10 seconds and then glow steadily once it gets into Measurement mode. If it does detect the GPS signal (satellites found etc..), it gives a series of 3 rapid flashes before going to the steady glow for Measurement mode.
  • Page 12: Data Files

    Data Files Sample data showing results of data collected with and without GPS activated. Note: GPS signal not found when recording data in lines 12 through 14. The data is stored in comma-delimited text files. These files can be opened with text-editing software (e.g. Micro- Soft Word) or spreadsheet software (e.g.
  • Page 13: Specifications

    Specifications Measurement Capacity: - 4,096 data points without GPS - 1,488 data points with GPS Operating Environment: - Weather Resistant Power: - 4 x AAA batteries - Provides 40 hours of logging Software Requirements: - Windows 95 or higher - Field Scout Software v. 3.4 or higher (included)
  • Page 14: Service And Support

    Who do I contact? Contact the company that you bought the loggers from: Spectrum Technologies, Inc. or a Spectrum Authorized Dealer. Before calling, you can evaluate and often solve your problem if you try the following.
  • Page 15: Warranty

    This product is warranted to be free from defects in material or workmanship for one year from the date of purchase. During the warranty period Spectrum will, at its option, either repair or replace products that prove to be defective. This warranty does...
  • Page 16: Thayer Court Aurora, Il

    This equipment has been manufactured for Spectrum Technologies, Inc. 3600 Thayer Court Aurora, IL 60504 USA The Manufacturer’s DECLARATION OF CONFORMITY is on file at the above address, and certifies conformity to the following: Model Number: 2120 Description: Data Logging pH Meter...

This manual is also suitable for:

Fieldscout ph 110

Table of Contents