Hyundai HY3810 Instruction Manual page 14

fuel flows into the pump.
2. Move the On / Off button to the "I" position. (B1)
3. Push the choke out to position 1. (B2)
4. Firmly grasp the front handgrip with your left hand, and the ignition
handgrip with your right hand. (B3)
5. Pull the ignition lever towards you until you feel resistance.
6. Pull the lever firmly against you.
NOTE: Do not pull the handle fully, as it may damage the starter.
7. Do not release the lever, but put it into the starting position.
8. Repeat steps 5 and 6 until the engine starts. When the engine
starts, push the choke to the working position (inside).
9. Lightly add the throttle and allow the engine to run for
approximately one minute to warm up to working temperature.
Choke (B2)
1. Position - cold ignition
2. Working position
Throttle button (B4)
The throttle button controls the speed of the chain rotation.
1. Use the right hand palm to press the button to lock the throttle
button (5) to release the gas feed button.
2. Press the throttle button (7) and the chain will start to rotate.
Stopping the engine
Move the On / Off button (8) to the "O" position to turn off the engine.
Chain brake (B6)
The chainsaw is equipped with a chain brake. In the event of a kickback,
this brake will stop the chain.
If kickback occurs during work, the hand guard hits your wrist. The hand
guard jumps forward and the brake stops the chain.
1. Push the hand guard forward to activate the chain brake.
2. Pull the hand guard back to release the chain brake.
Checking the brake
Regularly check if the chain brake is working properly.
1. The chainsaw should be turned on.
2. Push the hand guard forward to activate the chain brake.
3. Press full throttle for a short time (max. 2-3 seconds).
4. If the chain does not move, the brake is working properly.