Schlage Connect Homeowner's Manual page 2

4. General Operation
The lock is best used by entering your user code on the keypad to enter your unit. When
leaving, touch the touchscreen ("Schlage" logo to lock the door. This is the default "Lock and
Leave" mode.
1. Enter (unlock): Touch the "Schlage" logo at the top of the keypad, then enter your user
code. The door unlocks and a green arrow appears. If code is not correct a red 'X'
appears.
2. Exit (lock when leaving): Touch the "Schlage" logo at the top of the keypad. The door
locks.
3. Note: the lock can be programmed to require entering a code to lock (disable Lock and
Leave: see manual for instructions).
Your key can also be used (as in a conventional lock). For all programming using the
touchscreen, you need to enter your unique six-digit Programming Code. This can be found on
the back cover of your Schlage Lock Manual.
NOTE: The Programming Code allows anyone to freely program your lock. Therefore, the
Programming Code should be treated as you would a password or PIN: Please write it down
and keep in a secure location, along with your manual. User Codes (used to enter your unit)
should be treated similarly.
5. Programming the Lock
To program the lock, from the touchscreen (facing outside your unit, see Figure 1), the general
sequence is:
1. Touch the "Schlage" logo at the top of the touchscreen (above the keypad)
2. Enter your six-digit programming code (this is found on the back cover of your manual)
3. Enter a number between 1 and 9 to indicate the programming function desired
(add/delete user code, enable/disable vacation mode, enable/disable autolock feature,
etc.)
4. Depending on the operation, you will then enter a code (not required for all operations)
5. When a programming sequence is successful, the lock will blink and beep, and a green
check mark will appear on the touchscreen.
6. General sequence is thus: "Schlage" + Programming Code + 1 digit to select function.
After this, some functions require additional numbers and some do not. After successful
completion of operation, the touch screen will blink and beep (usually twice) and a
green check mark will appear.
Example Operation: Add/Delete a User Code
This can be used if, for example, you want to authorize entry to a user such as caregiver,
relative, service person. It can also be used if you want to change your own User Code. NOTE:
Page | 2
SCHLAGE CONNECT HOMEOWNER GUIDE
Richard Needham June 2021