Table of Contents
Advertisement
H4EKO-D
20. SAFETY INSTRUCTIONS
Residual risks and their prevention. The risks arising from the operation of the boiler under conditions of foreseeable use and
reasonably foreseeable misuse have been minimized by available technical means. Despite the constructional and technical
measures implemented, certain residual risks resulting from the risk analysis that are given by the technological process during
the different phases of the device's life remain in the boiler operation.
These include in particular the risks of inattentiveness of the boiler operator and failure to observe safety precautions during
operation. To further reduce the risks and ensure greater security efficiency, we draw attention to the possible occurrence of
certain residual risks that cannot be eliminated by any technical solution.
Risk Source
Means of transport - a truck, a personal car
of technician
Handling truck, forklift truck, arm of the
truck or other means by which the
equipment will be moved
Storage of devices, whether in a assembled
or disassembled state
Risk Source
a forklift, or other means by which the
equipment will be installed
assembly itself
Risk Source
Boiler body
Combustion chamber
Risks when supplying the boiler and its accessories
Risk Management
Restrictions on the movement of workers
(neighbors, family members) and machines
at the place where the equipment will be
unloaded from a car
There is a risk of injury or damage being
caused by parts of the devices that are
being moved
collisions of persons, machines, vehicles,
etc. with stored parts of the equipment.
Condensation of water in the wiring and
consequent injury of the technician, or
damage to equipment
Risks when placing the boiler at a designated location and completing it
Risk Management
There is a risk of injury or damage being
caused by parts of the devices that are
being moved
Injuries caused by a drill, angle grinder, and
common tools that technicians will use. E.g.
hammer, screwdriver, file, etc. The fall of
some of the device components.
Risks in normal boiler mode and its accessories
Risk Management
Burning damage by hot door (stoking,
cleaning, ashtray) when opened, hand or
face burning at the moment of opening
Hand injuries, burning damagy by the hot
smoke. Removing ash from the combustion
unloading and transporting individual parts
Mark the storage space appropriately. The
area must be dry so that moisture does not
Take extra caution if your staff or you are to
Doors open only with protective gloves, the
doors are in direct contact with flue gases
flue gases does not hit any part of the body.
The danger takes a few seconds before the
Manipulate with fireclay only in protective
gloves intended for this purpose and in the
cold state of the fireclay. The ash may still
chamber.
be hot, so store ash only at the designated
21
User manual
Hazard Elimination
Pre-define the unloading area and draw
attention to this fact of the employee
(neighbors, family members)
Thoroughly consider the strategy of
of the product to the location where the
product is temporarily stored or directly
assembled
get into the electrical installation
Hazard Elimination
help our technicians
If your staff or you, help our technicians,
have proper protective equipment. E.g.
protective goggles, working gloves, etc.
During the entire work, be extremely
cautious
Hazard Elimination
and can reach temperatures up to 400°C.
Open the door so that any spillage of hot
pressure inside filling chambre equals.
locations
Advertisement
Table of Contents
