Haier AB12CS1ERA Service Manual page 98

INSTALLING THE DRAIN HOSE
■
Install the drain pipe with downward gradient (1/50 to 1/100) and so there are no rises or traps in the pipe.
■
Use general hard polyvinyl chloride pipe (VP25) (outside diameter 38 mm)
■
During installation of the drain pipe, be careful to avoid applying pressure to the drain point of the unit.
■
When the pipe is long, install supporters.
■
Do not perform air bleeding.
■
Always heat insulate (8mm or over thick) the indoor side of the drain pipe.
(1) Install insulation for the drain pipe
Cut the included insulation material to an appropriate size and adhere it to the pipe.
(2) When drain pipe is put in the right rear position
Fasten the drain pipe with cable VT so that there is a proper slope for drain pipe to
exit from the indoor unit.
ELECTRICAL WIRING
Connect wiring to the terminals
A.For solid core wiring (or F-cable)
(1) Cut the wire end with a wire cutter or wire-cutting pliers, then strip the insulation to about 15/16"(25mm) to
expose the solid wire.
(2) Using a screwdriver, remove the terminal screw(s) on the terminal board.
(3) Using pliers, bend the solid wire to form a loop suitable for the terminal screw.
(4) Shape the loop wire properly, place it on the terminal board and tighten securely with the terminal screw using a
screwdriver.
96
Super Match