Haier AB12CS1ERA Service Manual page 51

Super Match
<Cautions for the drain water lifting pipe >
Installation height shall be less than 280mm.
There should be a right angle with unit, 300mm from unit.
Note:
The slope of water drain hose (1) shall be within 75mm, don't apply too much force on it. If several water hoses join
together, do as per following procedures.
Specifications of the water hoses shall meet the requirements for the unit
running.
(2) Check if water drainage is smooth after installation.
■ Check whether indoor unit is horizontal with leveler or polythene pipe filled with
water , and check that the dimension of the ceiling opening is correct. Take off
the lever gauge before install the ornament panel.
■
Fasten the screws to make the height difference between the two sides of
indoor unit less than 5mm.
■ First fix it with screws temporally.
■ Fasten the two temporally fixing screws and other two, and tighten the four
screws.
■
Connect the wires of synchronous-motor.
■
]Connect the wire of signal.
■
If no response of remote controller, check whether the wiring is correct, restart
remote controller 10 seconds after shut off power supply.
<Limits of panel board installation>
■ Install the panel board in the direction shown in the figure. The incorrect
direction will result in water leakage, meanwhile swing and signal receiving are
displayed that cannot be connected.
■
Charge, through air outlet or inspecting hole, 1200ccd water to see water
drainage.
After wiring
■
Check water drainage in cooling operation.
When wiring is not complete
■
Remove cover of control box, connect 1PH power to terminal 1 and 2 on
terminal block.,use remote controller to operate the unit.
■
Note, in this operation, fan will be running.
■ Upon confirmation of a smooth water drainage, be sure to cut off power
supply.
49
Electric control box
Electric control box
Connect with
outdoor unit
Terminal block
PCB on
indoor unit
Terminal block
Cover of controll box