Sauder Harvest Mill 404963 Manual page 23

Step 19
With someones help, carefully turn your unit over onto its front
å
edges. Unfold the LARGE BACK (P2) and lay it over the center of
your unit.
Make equal margins along all four edges of the LARGE BACK (P2).
å
Push on opposite corners of your unit if needed to make it "square".
Fasten the LARGE BACK (P2) to your unit using the NAILS (CCC).
å
Next, fasten the SMALL BACKS (O2) to your unit using the NAILS.
å
The SMALL BACKS will overlap the LARGE BACK.
NOTE: Be sure to tap NAILS into the holes that line up over the
å
UPRIGHTS (E, F, G, and H), TOPS (J and K), and SHELF (L).
NOTE: Perforations have been provided for access through the
å
LARGE BACK. Carefully cut out the holes needed.
Tap eight TACK GLIDES (RR) into the ENDS (A and B)
å
and UPRIGHTS (F and G).
Cut-out (used for lifting)
A
F
RR
www.sauder.com/services
The BACKS (O2)
will overlap the
LARGE BACK (P2).
O2
P2
G
B
404963
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
CCC
NAIL
(126 used in this step)
These holes must line up over the
UPRIGHTS, TOPS, and SHELF.
O2
For support, place packing
foam and magazines here.
Page 23