Lister 1800-1 Instruction Manual page 28

MALFUNCTION
EN
Top blade does not move
Clipper cuts badly or not at
all
Motor is not running
Motor runs very slowly
Running time of a fully char-
ged battery is too short and /
or blades are getting hot
The control light of the char-
ging station in not on
CAUSE
Clipperhead is not well
engaged
Drive carrier is defective
Clipper blade is blunt
Clipper blades have not been
correctly ground
Clipper blades are not oiled
The animal's hair is wet
Hairs jammed between top
and bottom blades
Clipperhead has too little clip-
ping pressure
Battery flat
Contacts dirty
Faulty battery
Smell of burning from the
motor housing. Motor burned
out.
Motor and / or electronics
faulty
Clipperhead blocked
Clipper blades were not oiled
sufficiently
Clipper blades were not oiled
sufficiently
Flat, not fully charged or faul-
ty battery is being used
Charging station is not
connected to the power
supply
Charging station is faulty
Page 28
RECTIFICATION
Engage the clipperhead
correctly when the motor is
running
Replace drive carrier (S)
Have top and bottom blades
resharpenend by service
centre (S)
Oil clipper blades every 10
minutes
Only clip dry hair
Take off clipperhead, push
the top blade half away from
the clipperhead, take away
hairs between top and bot-
tom blade.
Have clipperhead inspected
(S)
Charge battery
Switch clipper off and clean
the contacts
Replace battery (S)
Have motor and / or electro-
nics replaced (S)
Have motor and / or electro-
nics replaced (S)
Clean and oil clipperhead
Oil clipper blades
Oil clipper blades
Only use intact, fully charged
original batteries
Connect the charging station
to the power supply
Have charging station inspec-
ted (S)