Information Symbols; Proper Use; Personal Protective Equipment; Power Supply - Lister 1800-1 Instruction Manual

2.2.

Information symbols

EN
WARNING!
Indicates a potentially dangerous situation. If preventative action is not taken, death or
very serious injury could result.
ATTENTION!
Indicates a potentially dangerous situation.
NOTE!
Indicates tips and informations.
2.3.

Proper use

The equipment is exclusively designed and conceived for the here described use and intention.
The equipment is exclusively intended for use on dogs, cats, cattle and horses. The compliance
of all indications in this manual is part of the intended use. Other uses are expressly prohibited.
Expressly prohibited are:
•
•
2.4.

Personal protective equipment

Antislip shoes. For protection against slipping on slippery underground.
2.5.

Power supply

There is a danger of life in case of contact with life parts, therefore:
•
•
•
•
•
•
•
•
•
•
•
2.6. Animals
The noise of the clipper can trouble animals. A kick, an attack or the weight of the
Using the machine on persons.
Clipping other animals, in particular dangerous animals such as beasts of prey.
If you unplug the plug, always pull directly on the plug. Never pull on the cable,
it could get damaged.
If the isolation is damaged, disconnect immediately the power supply and
arrange reparation.
Before connecting to the power supply, compare the technical data with the
data of the power supply system and only connect in case of concordance.
Only plug the charging station in undamaged outlets.
Never wrap the cable around the machine and keep it away from hot underlays
and objects.
Keep humidity away from the machine. This can cause a short circuit.
Never clip wet animals.
Just clean the machine dryly with a brush and the cleaning brush.
Generally, never plunge the clipper and clipperhead into liquids such as water,
soapy water, diesel, petrol, etc. This may cause serious injury to mechanics and
motor.
Do not switch-on the clipper or the charging station if you suspect liquid to be
penetrated. Hand it over to a service centre.
Before starting any servicing work, disconnect the power supply; pull the plug
out. Even with the machine switched off, do not handle the area round the
clipper blades as long as the machine is still connected to a power source.
Whenever working on the clipper blades/clipper head, always first disconnect
the power supply.
Page 18