Fitting The Clipperhead - Lister 1800-1 Instruction Manual

EN
3. Insert the battery (2) in the clipper (3),
until the battery interlock (1) is engaged
on both sides.
If the clipper (1) and the spare battery (2) are standing simultaneously in the charging
station, only the battery in the clipper (1) is charging.
The spare battery (2) is only charging when the clipper is taken out of the charging
station.
6.1.3.

Fitting the clipperhead

1. If the blade hinge (2) is closed inadver-
tently, open it by the help of a screwdri-
ver (1).
2. Fit the clipperhead (1) on the open blade
hinge (2).
4. Put the clipper with the inserted battery
(1) or spare battery (2) from above
without force into the provided charging
cavity of the charging station.
5. Await the charging time (3 Technical
Data).
6. Battery is charging. During the charging
time the control light is illuminating
red (3). As soon as the battery is fully
charged, the green control light will light
up and the charger will switch to trickle
charge.
7. Hold the charger firmly with one hand
and pull the clipper (1) or the battery (2)
out with the other.
3. Fold the clipperhead (2) by light pressu-
re on to the clipper (1) which is switched
on.
4. Make sure, that the clipperhead (1) is
engaged firmly.
Page 24