Cleaning - Lister 1800-1 Instruction Manual

EN
Unsufficient lubrication of the clipperhead causes heating and a reduced durability of
clipper and blades, as well as a reduction of the battery runtime. Therefore:
•
•
Only use our special oil.
The blades must be oiled before, during and after every use. When the blades of the
clipper are leaving stripes or are running with reduced speed, this is a signal that oil
is required. Place a few drops of oil ahead and laterally on the clipper blades. Wipe
off the excessive oil with a smooth, dry cloth. Lubrication sprays do not have sufficient oil for a
good lubrication, but serve for cooling the blades. Immediately change damaged or crenated
blades to avoid injuries.
Remove all the leaking, used up or excessive grease from all the lubrication points,
and it is to be disposed in accordance with the local regulations.
6.2.5.
To receive good clipping results and to increase the durability of the clipper and the clipperhead,
it is necessary to apply a thin oil coat between top and bottom blade).
Clipperhead and hinge
Clean clipperheads und hinge between the different clippings.
Charging station
Contacts
If required, clean the contacts of the batteries and the clipper with a dry cloth.
When not in use daily, store the clipper and charging station in the provided case.
When in use daily, we recomend to put clipper and reserve battery in the charging
station.
Lubricate the blades sufficiently during the clipping (at least every 10 minutes),
so that they do not drain.
Only use the lubricants prescribed by the manufacturer.

Cleaning

1. Disconnect the charging station from the
power supply.
2. If necessary, take away hairs from both
charging cavities.
3. If required, clean the contacts (1) and (2)
with a dry cloth.
Page 26