WilTec TIG180 Operation Manual page 8

Parts list
№ Name
1 Indicator light
2 Welding current adjustment
3 Error light
4 Release time adjustment
Positive output terminal
– TIG: to connect TIG work piece cable
5
– MMA: to connect electrode holder or work
piece cable
Installation
If you want to use a cable that is longer than the one supplied, use one with a larger cross-section to
avoid voltage drops. If the torch cable or the electrode holder cable is too long, it may interfere with the
operation of the arc and other functions of the system. For this reason, we recommend that the user
stick to the accessories supplied to ensure propre function of the device.
Connecting the input cable
•
Each welding machine has a power cord, during the connection of which to the power supply
you have to make sure that it matches the input voltage of the device (230 V). If the mains cable
is connected to a higher voltage, the overvoltage protection is triggered. In this case, switch off
the power supply first and then connect the welding machine to a suitable mains connection
(230 V). You can now put the welding machine into operation.
•
Make sure the power cord is securely connected to the power switch or plug and prevent oxi-
dation. Check whether the line voltage is within the wave range.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
№ Name
2-pole connector, control cable for TIG
6
standard welding torch
Quick connector for TIG welding torch gas
7
conduct
Negative output terminal
– TIG: to connect TIG work piece cable
8
– MMA: to connect electrode holder or work
piece cable
9 MMA/TIG switch
10 Display
Item 61707, 61708 Page 8
05 2021-1