F) Reset Button; Troubleshooting - VOLTCRAFT BS-2000HD Operating Instructions Manual

f) Reset button

• If the product is not functioning correctly, you may need to perform a reset.
• With the power switched on, press the RESET button.
• Press and hold the power button

13. Troubleshooting

Problem
No image shown
After power on
After power on only words show
After connected to an external
monitor and the cable was
disconnected.
Cannot access microSD card
In "PC Connect" mode and the
USB cable was disconnected
Cannot access card
Cannot access card
Miscellaneous
Cannot capture photos or record
video
to switch the power back on.
Cause
Low battery
No camera detected
In "Video Output"
mode.
In "PC Connect" mode
Card was inserted
and removed multiple
times or the card was
removed too quickly.
Card was removed
during a recording or
image capture and the
card was damaged.
Storage device error
Solution
Charge the battery
Check all components are properly connected.
Press the ESC button 3x to exit "Video Output"
mode.
Exit "PC Connect" mode.
Insert the card again and wait a few moments for
the insert/remove status to refresh.
Check the card on your computer. If the problem
persists, try reformatting or replacing it.
All card data will be lost after formatting!
Check the microSD card:
• is correctly inserted
• read/write card lock is not on
• is correctly formatted. See "b) Get storage
ready" on page 23 for further information.
27