D) Button Functions - VOLTCRAFT KBM-700 Operating Instructions Manual

• Screw the protective cap tight as far as it will go.
• Electrolyte may leak as you screw the cap in place. Use a cloth to wipe away any leaking
electrolyte before use.
The electrode on the measuring probe must not be allowed to dry out again after initial
setup.
• If you require more electrolyte, it can be ordered as an accessory for redox probes using
Conrad item no. 1763049.
Measurement probes are consumable parts with a limited lifespan. For this reason,
measurement probes are not covered by the warranty/guarantee.

d) Button functions

Button Functions
1. Press this button to freeze a measured value on the LCD display.
2. Press and hold this button for approx. 3 seconds to switch to the min/
max display.
3. Briefly press this button to switch between the minimum and maximum
values.
1. Press this button to store a measured value.
2. Press and hold this button for approx. 3 seconds to recall a stored meas-
ured value and display it.
1. In memory recall, you can use these buttons to move through the stored
measurements.
2. Press and hold these buttons simultaneously for approx. 3 seconds to
switch to advanced settings (see section "i) Advanced settings").
1. Press this button to select the operating mode.
2. Press and hold this button for approx. 3 seconds to switch between the
temperature units °C and °F and between pH and mV, or between "ORP"
and "mV" in ORP mode.
1. Press this button to switch the meter on or off.
2. Press and hold this button for approx. 3 seconds to start calibration.
31