Wiring The Camera Module; Wiring The Camera Module With The Ip54 Protection Kit - Bosch FLEXIDOME IP indoor 8000i Installation Manual

18 en | Hardware installation
Wiring options
Chose one of the two possible wiring option:
–
–
6.2.1

Wiring the camera module

Notice!
i
IP5X ingress protection
If you wire the camera module according to the following instructions, the camera is
providing IP5X protection against dust ingress.
1.
2.
6.2.2

Wiring the camera module with the IP54 protection kit

Notice!
i
IP54 ingress protection
If you wire the camera module according to the following instructions, the camera is
providing IP54 protection against dust and water ingress.
Notice!
i
NDA-8001-IP IP54 protection kit
Use the NDA-8001-IP IP54 protection kit (sold separately) to wire the camera module with
IP54 ingress protection.
1.
2.
3.
2021-08 | 01 |
Wiring the camera module, page 18
Wiring the camera module with the IP54 protection kit, page 18
Remove the camera module from the box.
Connect the network cable to the RJ-45 connector of the camera module.
Remove the NDA-8001-IP IP54 protection kit from the box.
Put the RJ-45 punch-through aid on the network cable.
Remove the tube from the M20 rubber grommet.
Installation manual
FLEXIDOME IP indoor 8000i
Bosch Security Systems B.V.