Buick 2003 LeSabre Owner's Manual page 90

The alarm can be tested by following these steps:
1. From inside the vehicle, roll down the driver's
window and open the driver's door.
2. Activate the system by locking the doors with the
power door lock switch while the door
is
open, or
with the remote keyless entry transmitter.
3. Get out of the car, close the door and wait for the
4. Then reach in through the window, unlock the
SECURITY light to go out.
door with the manual door lock and open the
door. This should set off the alarm.
If the alarm does not sound when it should, but the
vehicle's lamps flash, check to see if the horn works.
The horn fuse may be blown. To replace the fuse,
see Fuses and Circuit Breakers on page 5-90.
If the alarm does not sound or the vehicle's lamps
do not flash, the vehicle should be serviced by
an authorized service center.
Your PASS-Key@ Ill system operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules and with Industry Canada.
This device complies with Pari 15 sf the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
This device complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation of the device.
Changes or modifications to this system by other than
an authorized service facility could void authorization to
I *PC\
thie
r r m l
m;nm-*.+
vucl
, I
,,d
b,yulyl
I I b I
I L .
PASS-Key@ Ill uses a radio frequency transponder in
the key that matches a decoder in your vehicle.
2-1 9