Buick 2003 LeSabre Owner's Manual page 170

Press the GAGE INFO button until the display shows
BATTERY STATE. If the voltage is normal the display will
show BATTERY STATE NORMAL. If the voltage drops
below 10.5 volts, the display will show BATTERY STATE
LOW. If the voltage is above 16.2 volts, the display will
show BATTERY STATE HIGH. If the display shows the
high or low message, you need to have your battery and
charging system checked.
Press the GAGE INFO button until OIL LIFE INDEX
appears in the display. The OIL LIFE INDEX NORMAL
display will show an estimate of the oil's remaining useful
life. When the oil life index is less than 10 percent, the
display will show OIL LIFE INDEX CHANGE OIL. When
you have the oil changed according to the maintenance
schedule (see Part A: Scheduled Maintenance Services
on
page 6-4 ), you will have to reset the oil life monitor.
To reset the Oil Life System, see Engine Oil on
page 5- 13.
Press the GAGE INFO button until TIRE PRESSURE
appears in the display. TIRE PRESSURE NORMAL is
displayed when the check tire pressure system believes
your vehicle's tire pressures are normal. It a potentlai tire
pressure problem is detected, the display will show
CHECK TIRE PRESSURE.
I f you see the CHECK TIRE PRESSURE message, you
should stop as soon as you can and check all your tires
for damage. If a tire is flat, see / f a Tire Goes Flat on
page 5-70. Also check the tire pressure in all four tires as
soon as you can. See Inflation -- Tire Pressure on
page 5-62 and Check Tire Pressure System on
page 5-63. There are times when you will have to reset
(calibrate) the Check Tire Pressure System. See Check
Tire Pressure System on page 5-63.
RESET: This button, used along with other buttons,
will reset system functions.
ENG/MET (English/Metric): Use this button to change
the display between English and metric units.
DIC messages can be displayed in one of three
languages: English, French or Spanish. The language
of the display is set by pressing both the FUEL
INFO and RESET buttons for five seconds. As the
buttons are held, each language will be displayed for
three seconds. Release the FUEL INFO and RESET
All DIC messages will now be in the selected language.
Language selection can also be done through the
DIC Personal Choice Programming. See "Language
Selection" later in this section.
I-
-
.- * I -
-
-1--:.---l
I
_ __. ._-_
; , . J:m-ln,,fiA
L U ~ ~ U I
IS W I I ~ I
I 11 IC U C ~ I I GU
l a 1
lyuayc
1 3
u a a p u y b u .
3-49