Buick 2003 LeSabre Owner's Manual page 188

Finding a Station
BAND: Press this button to switch between AM, FM,
FM2, or XMI, XM2 (USA only, if your radio is equipped
with XMTM Satellite Radio Service). The display will
show your selection.
TUNE: Turn this knob to choose a radio station.
ia SEEK Dl
:
Press the right or the left arrow to go to
the next or to the previous station and stay there.
To scan stations, press and hold one of the SEEK
arrows for two seconds until SCAN appears on
the display. The radio will go to a station, play for a few
seconds, then go on to the next station. Press one of
the SEEK arrows again to stop scanning.
To scan preset stations, press and hold one of the
SEEK arrows for more than four seconds until PSCAN
and the preset number appear on the display. You
will hear a double beep. The radio will go to the first
preset station stored on your pushbuttons, play for a few
seconds, then go on
to
tne next preset station. Press
one of the SEEK arrows again to stop scanning presets.
The radio will seek and scan only to the stations that
are in the selected band and only to those with a
strong signal.
Setting Preset Stations
The six numbered pushbuttons let you return to your
favorite stations. You can set up to 30 stations (six AM,
six FMI and six FM2, six XM1 and six XM2 (USA only,
if your radio is equipped with the XMTM Satellite
Radio Service), by performing the following steps:
1.
2.
3.
4.
5.
6.
Turn the radio on.
Press BAND to select AM, FMI or FM2,
or XMI, XM2.
Tune in the desired station.
Press EQ to select the EQ setting. It will be storea
with the preset station.
Press and hold one of the six numbered
pushbuttons. When you hear the radio produce
one beep, release the pushbutton. Whenever you
press that numbered pushbutton, the station you set
will
return.
Repeat the steps for each pushbutton.
J I
3-67