Advertisement
DEFINITIONS OF DIRECTIONS
As
used
throughout
this
definitions
apply:
"Right"
operator's
right and left when seated in the
operating
position
on the tractor.
"Rearward"
likewise refer to the directions
view-point of the operator.
FIGURE1
ASSEMBLING CHUTE DEFLECTOR
AND HEIGHT CONTROL LEVER
1. Remove banding
straps on carton by cutting
breaking. Removethe literature
discharge chute deflector,
lever from carton.
Slice carton open at the corners
andfold down the sides.
and remove all additional
mower.
CAUTION
Donot operate this mowerwithout the discharge
chute extension bolted securely inplace.
UNPACKING AND SET.UP
The operation
of the mower is controlled
operator's position onthe tractor
implement lift handleor electric clutch.
SET-UP INSTRUCTIONS
manual,
the
following
and "Left"
refer fo the
normal
"Forward"
and
from the
DEFLECTOR
or
bag, bag of parts,
and cutting height control
Remove mower from carton
packing
material from
OPERATING CONTROLS
See
INSTRUCTIONS.
from the
bythehydraulic lift,
2. Assemble discharge
chute deflector
mower housing, using two (short) carriage bolts, flat
washers,
lockwashers,
carriage bolts through deflector andthen through
mower housing. Tighten nuts finger
clamp to front and rear of deflector
housing using two (long)carriage bolts andnuts.
not use flat washers and lockwashers
Tighten nuts onclamps
clamps are bent to fit tight against mower housing.
Remove nuts from clamps
lockwashers.
Replace nuts
securely (See Fig. 1).
3. Slide
cutting
height
adjustment shaft onmower housing.
with pivot pin and 1/8 x 1/2 cotter pin. (Besure head
of pivot pin is towards
lever with long hole in quadrant
3/8-16 x 2 screw, large washer, spring, small washer,
and nut (See Fig. 2).
CUTTING HEIGHT
CONTROL LEVER
SCREW
FIGURE2
HYDRAULIC LIFT
To raise themower
to the transport
hydraulic lift lever rearward (SeeFig.
is raised upto the tractor.
lever.
To lower the mower for cutting,
hydraulic lift lever forward until the mower
desired cutting
height, then releasethe lever.
tounderside of
and
nuts,
by inserting
tight. Assemble
and m.ower
at this time.
securely with awr~nch until
and addflat
washers and
on clamp
and tighten
control
lever onto
roller
Secure inplace
rear of deck.) Line uphole in
and secure
with
NUT
COTTER PIN
position, move the
3) until the mower
frame, then releasethe lift
move the
is at the
Do
5
Advertisement
