Problem Solving - Rain i-dial Instructions Manual

PROBLEM SOLVING

Problem
The display shows
"No AC"
The rain sensor
does not stop the
system
The Display is
blocked or shows
incorrect informa-
tion
The controller irri-
gates endlessly
Warning:
units that are not expressly approved by the re-
sponsible for compliance could cancel the right
to make use of this equipment
28
Any unauthorized changes of this
Causes
There is no AC power (the
programmer
is not powered)
• Rain sensor defective
• Stations have been program-
med to keep out the sensor
Peak voltage
Too many start times have
been programmed
Solution
Check that the fuse is intact.
Check that the transformer is
connected properly
• Verify the operation of the
rain sensor and correct cabling
system
cablatura dell'impianto
• Program again the exclusion
of the sensor to activate it
Reset the programmer
Set up again the controller
NOTE: This device has been tested and com-
plaint declared with imposed limits on Class B,
Part 15 digital devices provided for the FCC Ru-
les.
These limits are designed to provide a reasonable
protection against harmful interferences in a resi-
dential location.
This equipment generates, uses, and can
emit radio frequency energy and, if not used
and installed in compliance with the instructions,