Installation; Mounting - Simrad Naviop Loop M User Manual

2

Installation

Mounting

Mounting guidelines
Choose the mounting location carefully, make sure that there are no hidden electrical wires or
other parts behind the panel before you drill or cut. Ensure that any cutting or drilling done is
in a safe position and will not weaken the boat's structure. If in doubt, consult a qualified boat
builder, or marine electronics installer.
Do not:
•
Mount any part where it can be used as a hand hold.
•
Mount any part where it might be submerged or exposed to moisture.
•
Mount any part where it will interfere with the operation, launching, or retrieving of the boat.
Do:
•
Consider the overall width and height requirements.
•
Leave sufficient clearance to connect all relevant cables.
•
Check that it is possible to route cables to the intended mounting location.
¼ Note:
to fit forced cooling.
!
the equipment may cause unreliable operation and reduced service life.
Exposing the equipment to conditions that exceeds the specifications could
invalidate your warranty. Refer to the "Technical Specifications" on page
30.
Egon+ board and OP-Box Loop M/M+
The recommended mounting orientation for the Egon+ board and the OP-Box Loop M/
M+ is horizontal (A). If horizontal mounting is not possible, it is recommended that devices
are mounted at an angle of 0-90° from horizontal (B). It is NOT recommended to mount the
devices at an angle greater than 90° from horizontal (C) due to drainage issues.
The OP-Box Loop M/M+ shall be mounted with 4 screws (not included in the kit).
The EGON+ board shall be mounted with 4 screws and 4 washers or brass grommets (not
included in the kit).
Installation |
The enclosure should be dry and well ventilated. In small enclosures, it may be required
Warning:
Inadequate ventilation and subsequent overheating of
A
Loop M User Manual
B C
| 7