Operation; Start Up; The Control Bar Interface - Simrad Naviop Loop M User Manual

4
26 |

Operation

Start up

When the system is powered, the Loop system will initialize. After the system is initialized,
normally less than 2 minutes after turning on the power, the system is ready to be used.
Warning:
!
Before using the system, wait for the system's initialization
procedure to end. If you are not able to operate the system, check the
display's power supply and restart the display. If the problem persists, stop
using the system immediately and contact an authorized service center.
The Loop system is operated from the MFD's control bar or from the Naviop application. Refer
to the MFD documentation for details about how to operate the MFD.

The control bar interface

Buttons
The button indicates the status of the connected equipment.
The buttons can be configured either as toggle buttons or as momentary buttons. Refer to
"Configuration" on page 21.
Toggle buttons changes status when pressed. If it is off it will be turned on when pressed and
vice versa.
Momentary buttons are activated as long as they are pressed.
Operation | Loop M User Manual
Off (black)
The relay is open.
On (blue)
The relay is closed.
Override (yellow)
The relay control is bypassed by an external
switch or the equipment is powered from
another source, not via the relay.
Error (red)
The fuse and/or relay is broken.