Selecting Re-Ignition Frequency - Biasi RINNOVA ADAPTIVE User Manual And Installation Instructions

Figure 5.47
• It is possible to modify the value of parame-
ter 12 from 01=10s to 120=1200s by press-
ing the 13 or 15 keys (each unit increase or
decrease on the display corresponds to 10
seconds).
• Press button 14 (Figure 5.43) to confirm the
value entered. The display will show the
following (Figure 5.48) for 5 seconds, then
move up to the next level.
Figure 5.48
• Press the keys 13 and 15 simultaneously (Fig-
ure 5.43) to exit the level without changing
the value (return to the previous level).
To exit the parameters menu:
• wait 15 minutes without pressing any key;
• switch off the electric power supply;
• press the 13 and 15 keys simultaneously for
5 seconds (Figure 5.43) (return to previous
level).

5.19 Selecting re-ignition frequency

When the boiler functions in normal on/off
heating mode, the minimum time between
INSTALLATION
two ignitions is set to 1 minute (re-ignition fre-
quency).
This time can be changed from a minimum
of 10 seconds to a maximum of 20 minutes in
programming mode, using either the control
panel or the remote.
• Enter "programming mode" by pressing the
13 and 15 keys simultaneously for 5 seconds
(Figure 5.49) until HiS (Boiler History) ap-
pears on the LCD display (Figure 5.50).
12
13
Figure 5.49
Figure 5.50
• Scroll through the various menus by press-
ing the keys 13 (back) or 15 (forward), until
PAr (Parameters menu) appears on the LCD
display (Figure 5.51).
• Press the 14 key for 1 second to enter the se-
lected menu.
Figure 5.51
• Scroll through the various parameters by
17
16
15
14
- 49 -