In Case The Audio Output Of The Subwoofer And Surround Speaker Is Unstable - Samsung HW-Q950T Full Manual

NOTES
• If the main unit is powered off, the wireless subwoofer will go into stand-by mode and the
STANDBY LED on the rear of the sub-woofer will turn red after blinking in blue several times.
• If you use a device that uses the same frequency (5.8GHz) as the Soundbar near the Soundbar,
interference may cause some sound interruption.
• The maximum transmission distance of the main unit's wireless signal is about 10 m, but may vary
depending on your operating environment. If a steel-concrete or metallic wall is between the main
unit and the wireless subwoofer, the system may not operate at all because the wireless signal
cannot penetrate metal.
CAUTION
• Wireless receiving antennas are built into the wireless subwoofer and Surround Speakers. Keep the
unit away from water and moisture.
• For optimal listening performance, make sure that the area around the wireless subwoofer and the
Surround Speakers are clear of any obstructions.

In case the audio output of the Subwoofer and Surround Speaker is unstable

When there is a wireless device (e.g., wireless LAN) using the same frequency (5.8GHz) near the
Soundbar, the wireless connection between the Subwoofer and Surround Speaker could become
unstable. This will affect the quality of audio output. In this case, the radio frequency channel of the
Subwoofer and Surround Speaker can be changed as below:
CAUTION
• It doesn't work when the display is off. Please turn on the display first by pressing the button on
the remote controller.
• Please press the WOOFER button vertically.
1. With the power of the Soundbar on, vertically press and hold the WOOFER button on the remote
controller for at least 5 seconds.
• The display shows "W-CH" and the currently set radio frequency channel.
5 Sec
ENG - 18
W-CH