Samsung HW-Q950T Full Manual page 19

2. Press the Up/Down button on the remote controller to change the radio frequency channel, and
then press the p button.
• The display shows "OK" and then the frequency is set to the changed channel.
• You can exit the setting mode by pressing any button other than Up/Down or p.
NOTES
• The default channel is the one that's optimised for avoiding wireless interference from external
devices. If there is no abnormal audio output (e.g., sound jitter or delays, noise) of the Subwoofer
and Surround Speaker, it is recommended to keep using the default channel.
• 3 to 6 channels are available for selection, depending on the radio specifications specific to each
country.
• Changing the radio frequency channel may affect the performance of other near wireless devices
(e.g., wireless LAN) using the same frequency bandwidth.
ENG - 19
OK