Table of Contents
Advertisement
To fully convert Model T32255 to operate on
220V:
1.
DISCONNECT MACHINE FROM POWER!
2.
Cut off existing 5-15 plug.
3.
Install 6-15 plug on power cord according to
plug manufacturer's instructions.
If plug manufacturer's instructions are not
available, NEMA standard 6-15 plug wiring
is provided on Page 29.
4.
Remove (4) hex bolts and flat washers
securing work light mounting bracket to buf-
fer (see Figure 11).
Work Light
Mounting Bracket
Figure 11. Work light mounting bracket and
securing fasteners.
5.
Loosen wire nuts indicated in Figure 12.
LED LIGHT
MOUNTING BRACKET
Loosen These
Wire Nuts
ON/OFF Switch
JI-HONG J9301-1YT
125/250VAC 19/12A
Figure 12. 110V LED work light wiring
connections.
Model T32255 (Mfd. Since 12/20)
x 4
Circuit Board
CX1918-VR-DIS-V1-1
MOTOR
6.
Remove (1) hex nut and lock washer secur-
ing 110V work light to mounting bracket (see
Figure 13) and remove work light.
Figure 13. Work light and securing fasteners.
7.
Insert 220V work light into mounting bracket
hole and secure with (1)
/
" lock washer.
1
2
8.
Use wire nuts from Step 5 to connect 220V
work light wires shown in Figure 14. Twist
wire nuts onto their respective wires and
wrap them with electrical tape so they will not
come loose during operation.
LED LIGHT
MOUNTING BRACKET
ON/OFF Switch
Figure 14. Buffer rewired to 220V work light.
JI-HONG J9301-1YT
125/250VAC 19/12A
9.
Secure work light mounting bracket to buffer
with fasteners removed in Step 4.
Partial 220V Conversion
110V LED
Light
Items Needed
Wire Cutters/Stripper ......................................... 1
NEMA 6-15 Plug ................................................ 1
Electrical Tape ................................... As Needed
Wrench or Socket
/
" ........................................ 1
1
2
Phillips Head Screwdriver #2 ............................ 1
To LED Light
/
"-18 hex nut and
1
2
Connect
Wires Here
Circuit Board
CX1918-VR-DIS-V1-1
Qty
MOTOR
110/220V
1
2 3
-15-
Advertisement
Table of Contents
