Kramer TP-590T Quick Start Manual

Scan for full manual
Step 1: Check what's in the box
TP-590T 4K HDMI/USB Transmitter
TP-590R 4K HDMI/USB Receiver
Step 2: Get to know your TP-590T and TP-590R
TP-590T
# Feature
1 HOST USB 2.0 Connector
2 ACTIVE HOST LED
3 IN LED
4 OUT LED
5 LINK LED
6 ON LED
7 HDBT OUT RJ-45 Connector
8 HDMI IN Connector
9 USB 2.0 Charging Connectors (3)
10 RS-232 3-pin Terminal Block
11 IR 3.5mm Mini Jack Connector
12 SETUP 4-way DIP-switch
13 5V DC Power Connector
TP-590T, TP-590R Quick Start
TP-590T and TP-590R Quick Start Guide
This guide helps you install and use your
Go to www.kramerav.com/downloads/TP-590T
download the latest user manual and check if firmware upgrades are available.
OR
Function
Connect to the USB host, (for example, a laptop) to communicate with the USB
peripheral devices (for example, a smart board) connected to USB device ports on
either the transmitter or the receiver.
Lights orange when the device is enabled as an active USB host (see
Connect inputs and
Lights blue when an active HDMI input signal is detected on HDMI IN.
Lights blue when an output device is connected to the receiver.
Lights green when the HDBT active link connection is established.
Lights green when the device receives power.
Connect to the HDBT IN RJ-45 connector on the receiver.
Connect to the HDMI source.
Connect to the USB local peripheral devices (for example, a mic, a keyboard, a
mouse and so on).
Connect to a controller device (for example, RC-306) to control a remote device via
serial connection (for example, the PTZ USB camera that is connected to the
receiver).
Connect to an external IR emitter to control a local IR-controlled device from the
receiver side (for example, TP-590R).
Connect to an IR sensor to control a remote IR-controlled device connected to the
receiver side (for example, TP-590R).
Sets the device behavior (see
Connect to the power supply.
TP-590T and TP-590R
and/or www.kramerav.com/downloads/TP-590R
1 Bracket set
1 Power cord
outputs).
Step 4: Connect inputs and
P/N: 2 9 0 0 - 3 0 1 4 2 4 QS
for the first time.
4 Rubber feet
1 Quick start guide
Step 4:
outputs).
Rev: 1
to