Table of Contents
Advertisement
Steps
1. Align the screw hole on the integrated microphone assembly circuit board with the screw hole on the chassis.
2. Insert the microphone and microphone bracket. Replace the screw that holds the microphone bracket in place.
3. Replace the screw (M2x5) that secures the integrated microphone assembly circuit board to the chassis and connect the
microphone cable to the connector on the system board. Close the latch to secure the cable.
Next steps
1. Install the
display
assembly.
2. Install the stylus.
3. Install the batteries.
4. Install the
system
cover.
5. Install the
battery cover
6. Follow the procedure in
Front camera
Removing the front camera
Prerequisites
1. Follow the procedure in
2. Remove the
batteries cover
3. Remove the
system
cover.
4. Remove the batteries.
5. Remove the stylus.
6. Remove the
display
assembly.
About this task
The figure indicates the location of the front camera and provides a visual representation of the removal procedure.
assembly.
after working inside the
tablet.
before working inside the
assembly.
tablet.
Field service information
51
Advertisement
Table of Contents
