Table of Contents
Advertisement
Installing the rear camera
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the rear camera and provides a visual representation of the installation procedure.
Steps
1. Align the screw holes on the rear camera circuit board with the screw holes on the tablet chassis.
2. Replace copper adhesive tape and the three (M2x5) screws to secure the rear camera circuit board to the chassis.
Next steps
1. Install the
system
board.
2. Install the
coin-cell
battery.
3. Install the
front
camera.
4. Install the microphone.
5. Install the WWAN.
6. Install the WLAN.
7. Install the
solid-state
8. Install the
system
fan.
9. Install the
SSD
heat-sink.
10. Install the
display
assembly.
11. Install the batteries.
12. Install the
system
cover.
13. Install the
battery cover
14. Follow the procedure in
drive.
assembly.
after working inside the
tablet.
Field service information
65
Advertisement
Table of Contents
