Table of Contents
Advertisement
3. Slide the battery latch to the locked state.
4. Ensure that the battery release latch is in the locked state.
Next steps
1. Install the
battery cover
2. Follow the procedure in
Subscriber Identification Module (SIM) card
Removing the uSIM
Prerequisites
1. Follow the procedure in
2. Remove the
batteries cover
3. Remove the batteries.
About this task
The figure indicates the location of the uSIM and provides a visual representation of the removal procedure.
Steps
1. Open the uSIM slot cap.
2. Press the uSIM card, and slide it out of the slot.
NOTE:
Use a flat pointed scribe to ease removing the SIM.
Inserting the uSIM
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
assembly.
after working inside the
tablet.
before working inside the
assembly.
tablet.
Field service information
27
Advertisement
Table of Contents
