Table of Contents
Advertisement
Steps
1. Align the front camera circuit board over the camera slot.
NOTE:
Opposite side of the camera circuit board is placed to connect cable in the connector.
2. Connect the front camera cable and plug in the cable to the connector.
3. Flip the front camera circuit board.
4. Align front camera circuit board with screw hole.
5. Place the camera lens case to the camera placeholder.
6. Replace the screw (M2x3) to secure the front camera circuit board on the tablet chassis.
7. Slide the lens shutter in the lens channel and push towards left.
8. Replace the adhesive tape on the camera assembly and system board shield.
Next steps
1. Install the
display
assembly.
2. Install the stylus.
3. Install the batteries.
4. Install the
system
cover.
5. Install the
battery cover
6. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
assembly.
after working inside the
tablet.
before working inside the
tablet.
Field service information
55
Advertisement
Table of Contents
