ETC High End Systems SolaPix 37 User Manual page 29

Set Display Settings
Navigate: Main Menu → Set → Disp. Setting
Parameter
Shutoff Time
Flip Display
Key Lock
Set the Temperature Scale
Navigate: Main Menu → Set → Temp. C/F
Select the temperature scale for the fixture:
Celsius (default value)
•
Fahrenheit
•
Update Fixture Firmware Using the USB Port
Navigate: Main Menu → Set → USB Update
Fixture firmware updates are available on the ETC website at
Events.
1. Save the firmware update file to a USB drive.
2. Insert the USB drive in the fixture base (see
location).
3. On the Main Menu, select Set → USB Update. The fixture reads the USB drive and
displays a list of any firmware update files on the USB drive.
4. Select the appropriate file and then press the Enter button.
5. The software prompts you to confirm the update with the message "Update fixture?" Use
the navigation buttons to select "Yes," and then press the Enter button.
The firmware update begins. A progress monitor shows you the progress of the
•
update.
The fixture restarts when the update is complete, and the fixture performs a data
•
check to verify the update.
The firmware update is complete when the display returns to its default state.
•
6. Remove the USB drive from the fixture.
Reset Fixture to Factory Default Settings
Navigate: Main Menu → Set → Reset Default
Select ON to reset the fixture to the factory default settings.
Configure the Fixture
Value Description
Enter the amount of time the fixture waits after the
02–60 minutes last user interface button press until the display goes to
sleep. The default value is 5 minutes.
Flip the display 180° when the fixture is mounted
vertically. The default value is OFF.
ON
•
Shortcut: With the main UI window displayed, press
OFF
•
[>] to flip the display 180°. Press [<] to flip it back to
its original orientation.
Lock the user interface. The default value is OFF.
ON
•
To unlock the user interface buttons, press and hold
OFF
•
the [MODE/ESC] button for three seconds.
etcconnect.com/Products/Live-
Fixture Overview on page 6
for the USB port
25