Table of Contents
Advertisement
Flush Mounting (mm)
X 916
Y 500
P 934
Q 519
F 40
G 57
1 Electrical connection
Mounting
Over built-in oven unit
The clearance between the hob and the kitchen
units or other built-in appliances must be enough
to ensure sufficient ventilation and air discharge.
If installed above an oven, a space must be left
between the bottom of the hob and the top of
the appliance installed below.
1 Opens on bottom
2 Opens on bottom and back
Proper ventilation
To ensure correct air circulation, there must be a
minimum distance between the back of the
appliance and the built-in cabinet (A) and
between the bottom of the appliance and any
50 - INSTALLATION
unit or appliance under it (B).
A min. 10 mm
B min. 2 mm
Instructions for the installer
Electrical connection instructions
• If you use a plug (if present) to connect to
the power supply, the plug must be
accessible after installation.
• Do not bend or trap the power cable.
• Use cables that are flexible and heat-
resistant (e.g. SiHF-J).
• Place cable lugs on the ends of the wires
before connecting to the induction
generator.
• Keep the individual cables as short as
possible inside the junction box (where
present).
• Cables held together by cable clips should
be kept as long as possible.
• Proper earthing and insulation is mandatory
(verified by high voltage tests) in
accordance with EN 50106.
• Increase the operating voltage gradually,
not abruptly, to avoid damaging the
appliance.
General instructions
• The appliance must be installed according
to the installation diagrams.
• It is mandatory to carry out a functional test
for the entire surface of the hob to make sure
that the automatic pan detection system is
working correctly.
• If the appliance does not work correctly
after having carried out all the checks,
contact your local Authorised Service
Centre.
• Once the appliance has been installed,
please explain to the user how to use it
correctly.
914779706/B
Advertisement
Table of Contents
