Table of Contents
Advertisement
adjacent furniture should be temperature-
resistant (>90°C), otherwise they might
warp over time.
• If the piece of furniture does not have the
required recess opening, either it will have
to be cut or masonry work carried out by a
competent technician.
• The minimum clearance between exhaust
hoods and the cooking surface must be at
least the distance indicated in the exhaust
hood installation instructions.
• The minimum clearances must also be
respected for the edges of the hob on the
back as indicated in the assembly
instructions.
• If the appliance is to be installed above an
oven, the oven must be fitted with a cooling
fan.
Appliance overall dimensions (mm)
L 913
Built-in cabinet dimensions (mm)
A min. 50
B min. 460
C min. 750
D 20 - 60
E min. 50
L 913
Hob seal
To prevent leakage of liquid between the frame
of the hob and the countertop, place the
adhesive seal provided along the entire outer
914779706/B
edge of the hob before assembly.
Do not use silicone to secure the hob.
This would make it impossible to remove
the hob without damaging it.
In the case of flush mounting, after placing the
adhesive seal (A) on the glass surface and after
positioning and securing the hob, fill the edges
with insulating silicone (B) and wipe off any
excess. If for any reason the hob needs to be
removed, cut the silicone using a cutter before
attempting to remove it (C).
Semi-flush mounting (mm)
X 916
Y 500
F 40
G 57
1 Electrical connection
INSTALLATION - 49
Advertisement
Table of Contents
