Turning The Appliance On - DeLonghi PAC T120EK Instructions For Use Manual

TURNING THE APPLIANCE ON

Plug into the mains socket, then the appliance is standby.
Press the button to make the appliance turn on. The last
function active when it was turned off will appear.
Important! Never turn the appliance off by
unplugging from the mains. Always press the button
, then wait for a few minutes before unplugging.
This allows the appliance to perform a cycle of checks
to verify operation.
COOL mode
Ideal for hot muggy weather when you need to cooling and
dehumidify the room.
To set this mode correctly:
• Press the M button a number of times until the
symbol appears.
• Select the target temperature18°C-32°C (64°F-90°F) by
pressing the or
value is displayed.
• Select the required fan speed by pressing the
button.
• Fan speed can be selected: High, Med, Low, Auto
High speed: for maximum fan power
Med speed: reduces noise levels but still
maintains a good level of comfort
Low speed: for silent operation
Auto speed: the appliance automatically
selects the most suitable fan speed in
relation to the temperature set.
The most suitable temperature for the room during the
summer varies from 24°C to 27°C (75°F to 81°F). You are
recommended, however, not to set a temperature much
below the outdoor temperature. The fan speed difference is
more noticeable when the appliance is under FAN mode but
may not be noticeable under COOL mode.
Turning the appliance on
button until the corresponding
FAN mode
When using the appliance in this mode, the air hose does not
need to be attached.
• Press the M button a number of times until the
symbol appears.
• Select the required fan speed by pressing the
button.
• Fan speed can be selected: High, Med, Low.
DRY mode
Ideal to reduce room humidity (spring and autumn, damp
rooms rainy periods, etc).
In dry mode, the appliance should be prepared in the same
way as for cool mode, with the air exhaust hose attached to
enable the moisture to be discharged outside.
To set this mode correctly:
• Press the M button a number of times until the
symbol appears.
• In this mode, fan speed is selected automatically by the
appliance and can not be set manually.
Switch the unit of temperature
When the appliance is running, hold on
together 3 seconds by the same time, then you can change
the unit of temperature.
For example:
Before change, in cool mode, the screen display like fig 1.
After change, in cool mode, the screen display like fig 2.
1
8
en
and button
2