How To Hang Your Ceiling Fan - Emerson CF654AW01 Owner's Manual

WARNING
!
The fan must be hung with at least 7' of clearance
from floor to blades (Figure 7).
AT LEAST
7'
Figure 7
WARNING
!
The outlet box and joist must be securely mounted
and capable of supporting at least 50 lbs. Use only a
U.L. outlet box listed as "Acceptable for Fan Support
of 22.7 kg. (50 lbs.) or less".
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable
for Fan Support of 22.7 kg. (50 lbs.) or less", and use
screws supplied with outlet box. Most outlet boxes
commonly used for support of light fixtures are not
acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
1. Securely attach the hanger bracket to the outlet box
using the two screws supplied with the outlet box
(Figure 8).
TWO SCREWS
SUPPLIED WITH
OUTLET BOX
Figure 8

How to Hang Your Ceiling Fan

CEILING
FLOOR
OUTLET
BOX
HANGER
BRACKET
TAB
!
Hanger bracket must seat firmly against outlet box. If
the outlet box is recessed, remove wall board until
bracket contacts box. If bracket and/or outlet box are
not securely attached, the fan could wobble or fall.
2.Carefully lift the fan from the foam pad and seat the
hanger ball/downrod assembly on the hanger
bracket that was just attached to the outlet box
(Figure 9). Be sure the groove in the ball engages
with the tab on the hanger bracket (Figure 8).
!
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
OUTLET
BOX
Figure 9
!
To avoid possible fire or shock, do not pinch wires
between the hanger ball/downrod assembly and
hanger bracket.
6
WARNING
WARNING
NOTE: CEILING COVER,
SUPPLY WIRES AND
FAN WIRES OMITTED
FOR CLARITY.
HANGER
BRACKET
HANGER BALL/
DOWNROD ASSEMBLY
WARNING
U.L. Model No.: CF654