Elo TouchSystems ET1517L User Manual page 24

Touchmonitor

a) Verify as an emission source by turning the equipment off and on.

If you determine that this equipment is causing the interference, try to correct the interference

by using one or more of the following measures:

i) Move the digital device away from the affected receiver.

ii) Reposition (turn) the digital device with respect to the affected receiver.

iii) Reorient the affected receiver s antenna.

iv) Plug the digital device into a different AC outlet so the digital device and the receiver are

on different branch circuits.

v) Disconnect and remove any I/O cables that the digital device does not use.(Unterminated

I/O cables are a potential source of high RF emission levels.)

vi) Plug the digital device into only a grounded outlet receptacle. Do not use AC adapter

plugs. (Removing or cutting the line cord ground may in crease RF emission levels and may

also present a lethal shock hazard to the user.)

If you need additional help, consult your dealer, manufacturer, or an experienced radio or

television technician.

Table of Contents

Show Quick Links

Et1717l