Chapter 7: Regulatory Information - Elo TouchSystems ET1517L User Manual

Touchmonitor

Chapter 7: Regulatory Information

I. Electrical Safety Information:

Compliance is required with respect to the voltage, frequency, and current requirements

indicated on the manufacturer s label. Connection to a different power source than those

specified herein will likely result in improper operation, damage to the equipment or pose a fire

hazard if the limitations are not followed.

There are no operator serviceable parts inside this equipment. There are hazardous voltages

generated by this equipment which constitute a safety hazard. Service should be provided only

by a qualified service technician.

Contact a qualified electrician or the manufacturer if there are questions about the installation

prior to connecting the equipment to mains power.

II. Emissions and Immunity Information

Notice to Users in the United States:

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Notice to Users in Canada:

This equipment complies with the Class B limits for radio noise emissions from digital

apparatus as established by the Radio Interference Regulations of Industrial Canada.

Table of Contents

Show Quick Links

Et1717l