Product Description And Intended Use; Safety Instructions - FIAM. PINCH PI/70 Product Information

PINCH Mirror
EN
Art. PI/70 - PI/90 - PI/160 - PI/180
Read this information carefully before using the product and keep it for
future reference. Failure to comply carefully with the instructions which
follow may put the safety of the product and its users at risk.

Product description and intended use

1
• Product description and composition
The PINCH Mirror - Art. Code PI/70 - PI/90 - PI/160 - PI/180 is a Mirror intended as an item of indoor furniture. It is manufactured from float
glass and steel. The PINCH Mirror was produced at the FIAM ITALIA srl factory at Via Ancona 1/B, 61010 Tavullia (PU), Italy - Tel:
+39.0721.20051 - Fax: +39.0721.202432 - www.fiamitalia.it
• Intended use
The article known as PINCH is designed and built to serve as a Mirror for indoor use and must therefore be used only for this purpose and
no other.
For more information about the product's intended use please refer to section "2) SAFETY INSTRUCTIONS".

Safety instructions

2
To ensure that our product is used in the conditions of the utmost safety, we urge you to comply with the safety instructions
provided below. If in doubt or if you require further information concerning the use of the product, please contact us on the
telephone numbers stated in this document.
• Transporting and storing the PINCH Mirror in the original packaging
The PINCH Mirror, in its original packaging, must be transported taking the greatest care to prevent knocks and shaking. It must
be stored indoors in a dry place.
Place the PINCH Mirror in the original packaging, in the horizontal position. The arrows on the label on the packaging must be
vertical and pointing upward.
Never place weights or loads in excess of 100 Kg on the original packaging, since exceeding this weight may cause the breakage
of the article.
The PINCH Mirror in the original packaging weighs about 23 kg max.
• Removing the packaging - assembly
To remove the original packaging of the PINCH Mirror, proceed as follows.
a) Place the packaging crate horizontal. The arrows on the labels on the outside must be vertical and pointing upward.
b) Open the packaging crate and remove the sheets of polystyrene. Do not use hammers, saws, cutters or other tools which may
damage the PINCH Mirror.
c) Remove the PINCH Mirror from its packaging. At least two people are required for this operation. Wear gloves which assure a
good grip on the float glass.
d) Fix the Mirror to the wall following the instructions provided.
11/20